TECHNICAL DATA

Appearance: White liquid

Packaging: Bidon 1 kg / 5kg / 25kg

Storage: Store in a dry place on wooden pallets

Storage time: 24 months from date of production.

Volume mass: 1.04 gr / cm3

Storage Time: 12 months from date of production

Capacity: 1300 kg / m3

Viscosity: 30 mPas

pH of the mixture: 7.5

Application temperature: + 5 ° C to + 35 ° C.

Tile adhesive values ​​after mixing with D-ELASTIC:

Adhesion strength after 28 days (normal conditions): ≥ 1 N / mm2

Adhesive strength after immersion: ≥ 1 N / mm²

Adhesive strength after heat reaction: ≥ 1 N / mm²

Adhesive strength after freeze-thaw cycles: ≥ 1 N / mm²

Fire Reaction: Class A1

Polymer-based latex-based, aqueous dispersion polymer additives, reduce the amount of water, increase adhesion, increase flexibility and mechanical resistance. Recommended for preparing C2 grade resilient tile adhesives.

 

SUPPORT PREPARATION

 

Cement-based supports must be durable, resistant  and regular, oil-free and non-dirty, and no paint residue and must have reached maturity in advance. Approximately traditional cement-based floors with normal hardening time should have a shelf life of at least 28 days, traditional plaster plates should dry for at least 14 days. Large bumps or cracks should be adjusted in advance. All types of support should be cleaned in advance before applying the product mechanically with a vacuum cleaner.

 

MIXTURE PREPARATION

 

Mix well before use. Pour the prescribed amount of D-ELASTIC into a clean container and then discard the powdered material until you reach a homogeneous mass, with uniformity in plasticity and color. Leave the mass created to cool for 10 minutes and then make a small reshaping before applying the product. The workability of the mixture is 2-3 hours under normal temperature conditions (20 ° C).

Polymer-based latex-based, aqueous dispersion polymer additives, reduce the amount of water, increase adhesion, increase flexibility and mechanical resistance. Recommended for preparing C2 grade resilient tile adhesives.

 

APPLICATION AREA

 

For the preparation of cement-based adhesives. For gluing ceramic tiles of any type, natural stones on horizontal and vertical foundations, indoors and outdoors. On new plaster boards, on poor concrete and layer.

 

APPLICATION

 

The mixing water to prepare the tile starch is replaced with a mixture of D-ELASTIC and water, in 1: 1 to 1: 3 ratios, by volume. First mix the amount of latex with water and then add the cement-based product to avoid creating air bubbles. It is recommended that the tiles do not get wet before application, only if the tile is very dusty. The tiles are placed by applying a slight pressure on the tile thus providing a contact across the cough surface. The correction time is 20-30 minutes. The product correction time depends heavily on weather conditions, so before placing the plate to ensure that the adhesive does not form a film layer on the surface.

 

BE CAREFUL !

 

The mass of the mixture should not be too watery. For gypsum surfaces, cardboard-grips, etc., first apply a special primer. Avoid outdoors outdoors in high winds and temperatures below + 5 ° C and above + 35 ° C by protecting the plinths from heavy rain for at least 24 hours and frosts and direct sunlight. at least 5-6 days after application. Application of the product should be done according to the instructions of the technical file.